Cisco ASA Firewalls

There are multiple different methods of extracting the configuration from your Cisco Security Appliance, this guide outlines just three of those.

Using ASDM And PDM

The ASDM and PDM interfaces can be accessed using a web browser with Java capabilities. Whether you have access to ASDM or PDM will depend on your security appliance (and its age), but the procedure is the same for both. The procedure for getting the configuration from the your device is as follows:

Using your favorite web browser, connect to the HTTPS service provided by your Cisco device for remote management. You can do this by entering "https://" followed by your devices IP address.
On ADSM-capable devices, click on the Run ADSM as a Java Applet button.
Logon using your administration username and password.
You should now see the ADSM or PDM application, both of which are shown in the screens below.
You can show the running-config using the option on the File menu.
Copy and paste the configuration into a file to use with Nipper.

A screenshot of a computer

Description automatically generated

Using TFTP

We don't recommend using TFTP to transfer your configuration due to weaknesses in the protocol, the other methods described in this section are more secure. However, here is the procedure for using TFTP:

Connect to the Cisco device using SSH, Telnet, ASDM, PDM or through a Console connection.
Login to your Cisco PIX device.
Transfer the configuration using the TFTP command
Copy
```
write net ip-address:filename
```

Using SSH, Telnet Or The Console

For this procedure you will be using the Command Line Interface (CLI) of your Cisco device using an SSH client (such as OpenSSH or Putty), Telnet or through the console port. We would recommend using either SSH (for remote connections) or using a direct connection to the console port. Telnet provides no encryption of the communications and therefore your authentication credentials and configuration would be vulnerable if a malicious user were to monitor your connection.

Connect to the Cisco using your favorite SSH client, Telnet or a direct console connection.
Logon using your administration authentication credentials.
Enter
Copy
```
enable
```
and type in your enable password.
Execute the following CLI command and capture the output (possibly using the cut and paste facility):

Modern Configuration Retrieval (ensures pre-shared keys and passwords are unmasked):
Copy
```
more system:running-config
```
Alternative Legacy Command:
Copy
```
show run
```
Save the captured output to a file and remove any visible page lines (i.e. --More--).